Altair Activate® software is an open & flexible tool for
rapidly modeling and simulating products as
multi-disciplinary systems in the form of 1D models
(expressed as signal-based or physical block diagrams),
optionally coupled to 3D models.
Leverage a flexible spectrum of simulations throughout your
development cycle – ranging from early concept design (with
models involving more abstraction and typically shorter
simulations) to later detailed design (with less model
abstraction & longer simulations).
Simulating at the system-level
enables performance assessment of the complete product,
rather than only of a portion of the product.
Block Diagrams: Control System Design
Providing a natural modeling approach for developing
today’s smart systems involving sensors, actuators,
feedback, and built-in logic.
Mix Signal-based and Physical Modeling in Same Diagram
Leveraging the power of pre-defined Modelica libraries for
modeling common Mechanical, Electrical, and Thermal
Typically much Faster than 3D Simulations
Relying on greater levels of model abstraction enables more
product-performance insight earlier (i.e., nearer the
Concept Design stage) and rapid design exploration.
Connections to Other Altair Tools
Enabling true multi-disciplinary system simulation via
model exchange or co-simulation with MotionSolve for
controlled multi-body dynamics, with Flux for controlled
motor dynamics models, etc.
Seamless integration of 0D-1D and 3D worlds
This webinar will introduce you to Altair Activate for
control system design and the ease of solving real world
problems with co-simulation between MotionSolve (multibody
simulation suite) and Activate.
Support for Functional Mockup Interface (FMI)
Including Functional Mockup Units (FMU) enables model
exchange or co-simulation connections to non-Altair tools
which also support the FMI standard